User manual

User Manual 5 Y1-03-0203 Rev.K
1.2 Entering the MMSI and IMO Numbers
Select from the Main Menu “Service Configuration” Number 6. Menu is SERVICE password
protected with default password “NAUT”. Enter Service Password and use the up and down arrows
on keypad to select “Change MMSI / IMO” than press M5 “Select” or “by pressing number 3 on the
keypad.
Input your MMSI and IMO number and press Save to store data. Unit will reboot itself after pressing
Save. Continue to 4.2 after reboot, if no IMO number is available use the value 0 (Zero).
Service Configuration Menu Example:
Note: MMSI and IMO Data input are limited to 9 characters.
N 1
o
21' E 0
o
1
4' |1>0.01|2>1.30|3>1.80nm
|----------------------------------
| 6. Service Configuration
-----| |
| +- 1. Change Service Password
View | +- 2. User Password Settings
| +- 3. Change MMSI / IMO
-----| +- 4. Restore Factory Settings
|
Msg. |
|
-----|
|
Displ|
----------------------------------------
NUM| Select->| | |<-Back
N 1
o
19' E 0
o
13' |1>
0
.01|2>1.30|3>1.80nm
|----------------------------------
| Menu
-----| |
| +- 1. Messages
View | +- 2. AIS Status
| +- 3. Voyage Settings
-----| +- 4. Ship Settings
| +- 5. Transponder Configuration
Msg. | +- 6. Service Configuration
| +- 7. Display Settings
-----| +- 8. Graphical Display Settings
|
Displ|
----------------------------------------
NUM |Select->| | <-Back