User Manual

Y1-03-0180 Rev. T1
13
receiver is properly connected to the beacon, this “default” data will be replaced by valid GPS
position data, as described in the previous sections.
Position data will be reset to default by activating the beacon (by placing the thumb switch in the
ready position and then pressing one of the remote activation points) and then turning the beacon
off by returning the thumb switch to the off position. Once the beacon is in ON mode, it must be
turned OFF within approximately 50 seconds to prevent transmission of a live burst. Because the
activation points must be remote from the beacon, it is recommended that two people with 2-Way
radios perform this procedure to prevent false alarms.
NOTE: THIS BEACON IS AUTHORIZED FOR USE ONLY DURING SITUATIONS
WHERE THE SECURITY OF YOUR VESSEL IS UNDER THREAT OR HAS BEEN
COMPROMISED AND POLICE ACTION IS REQUIRED.
ALSO NOTE: The action of turning the beacon ON and then OFF clears any stored GPS position
data.
SECTION 5 - CARE AND MAINTENANCE
5.1 At least every ninety days, the mounting bracket and ThunderBird S.S.A.S. should be inspected
for deterioration and/or buildup that may affect the function of the beacon or its mounting.
Also carefully inspect the S.S.A.S case for any visible cracks. Cracks may admit moisture, which
could falsely activate the beacon or otherwise cause a malfunction. Any cracking observed
should be immediately referred to ACR for evaluation, (1-800-432-0227 Ext. 112)
5.2 Clean the beacon and the mounting bracket to remove residue buildups. It is recommended that
the mounting bracket be wiped with a damp cloth.
5.3 Check coaxial connector on cable from the antenna for tightness.
5.4 The battery (P/N 1096) must be replaced by the date indicated on the beacon. At each inspection,
check the time remaining until replacement is required. Battery should be replaced if the beacon
has been activated for any use other than the self test.
NOTE: There are no user serviceable items inside the S.S.A.S. DO NOT OPEN THE S.S.A.S
UNLESS TO DISABLE IN CASE OF FAULTY ACTIVATION.
Self contained long life batteries with a five-year recommended replacement cycle provide power.
See Factory Authorized Service Center for replacement.
Battery replacement includes servicing the S.S.A.S by replacing all o-rings, testing the water seal
and the electrical properties.
Always refer all long life battery replacement and other S.S.A.S service to a factory authorized
service center.
For the nearest location of a factory authorized service center, call 1-800-432-0227 Ext. 112 (toll
free) or visit our website at www.acrelectronics.com