User`s guide

Enclosure Components
007-4522-003 11
Figure 1-5 JBOD (Expansion) Enclosure Components, Rear View
These components are discussed in the following sections:
• “Operators (Ops) Panel” on page 11
• “PSU/Cooling Module” on page 12
• “RAID LRC I/O Modules” on page 14
• “RAID Loopback LRC I/O Modules” on page 16
• “JBOD LRC I/O Module” on page 18
• “Drive Carrier Module” on page 19
• “Enclosure Bay Numbering” on page 22
Operators (Ops) Panel
The operators panel (ops panel) contains an enclosure services processor that monitors
and controls the enclosure (see Figure 1-6). The ops panel contains LEDs which show the
status for all modules, an audible alarm that indicates a fault state is present, a
push-button alarm mute switch, and a thumb-wheel enclosure ID address range selector
switch. When the 2 Gb TP9100 is powered on, the audible alarm sounds for one second,
and the power-on LED illuminates.
ID
RS232
FC-AL Loops
RS232
FC-AL Loops
Operators
panel
JBOD LRC/IO
module B
JBOD LRC/IO
module A
PSU/cooling
module
PSU/cooling
module