User`s guide

100 007-4522-003
6: Installing and Replacing Drive Carrier Modules
Replacing the Disk Drive Module
If an LED indicates that a disk drive is defective, follow these steps to remove the faulty
drive:
1. Make sure enough disk drives and dummy drives are available to occupy all bays.
2. Ensure that users are logged off of the affected systems; back up data if necessary.
Note: Replace disk drive modules one at a time.
3. If the drive module is locked, insert the key into the anti-tamper lock and turn it 90
degrees counterclockwise. The indicator in the drive carrier module turns black
when the drive is unlocked.
Figure 6-5 Unlocking the Disk Drive Module
4. Ensure that the faulty drive has spun down.
Caution: Damage can occur to a drive if it is removed while still spinning.
5. Open the handle by pressing the latch on the module handle towards the right.
Then gently slide the module out of the enclosure approximately 25 mm (1 inch)
and wait 30 seconds. See Figure 6-6.
Torx screwdriver
!