User`s guide

98 007-4522-003
6: Installing and Replacing Drive Carrier Modules
6. Swing the drive handle shut and press it to seat the drive carrier module. The
camming lever on the right of the module will engage with a slot in the chassis.
Continue to push firmly until the handle fully engages with the module cap. You
should hear a click as the latch engages and holds the handle closed.
7. Repeat steps 2 through 6 for all drive modules to be installed.
8. When you have finished installing the drive carrier module(s), activate the
anti-tamper lock(s). Insert the key and turn it 90 degrees clockwise. The indicator in
the drive carrier module turns red when the drive is locked. See Figure 6-4.
Figure 6-4 Locking the Drive Carrier Module
9. Fit any empty drive bays with dummy drive carrier modules. The drive handle and
camming mechanisms operate the same way that those in a standard drive carrier
module do.
Replacing a Drive Carrier Module
This section explains how to replace a defective drive carrier module in the following
sections:
Torx screwdriver