User`s guide

96 007-4522-003
6: Installing and Replacing Drive Carrier Modules
Warning: The disk drive handle might have become unlatched in shipment and
might spring open when you open the bag. As you open the bag, keep it a safe
distance from your face.
3. Place the drive carrier module on an antistatic work surface and ensure that the
anti-tamper lock is disengaged (unlocked). A disk drive module cannot be installed
if its anti-tamper lock is activated outside the enclosure.
Drives are shipped with their locks set in the unlocked position. However, if a drive
is locked, insert the key (included with the disk drive) into the socket in the lower
part of the handle trim and turn it 90 degrees counterclockwise until the indicator
visible in the center aperture of the handle shows black. See Figure 6-1.
Figure 6-1 Unlocking the Drive Carrier Module
4. Open the handle of the replacement carrier by pressing the latch handle towards the
right (see Figure 6-2).
Torx screwdriver