Manualshelf

Installation Guide

ManualsBrandsACQUA FLOORS ManualsBamboo FlooringSpiced Anise 1/4 in. T x 5.125 in. W 72.75 in. x L Waterproof Bamboo Flooring (20.71 sq. ft./case)
123456789
8
October 9, 2020
GLUE-DOWN INSTALLATION INSTRUCTIONS
Step One - Establish a Starting Point
1.1 Remove any existing wall base, shoe molding, quarter round or doorway threshold.
1.2 Determine the direction of the floor joists and run the flooring perpendicular (90°) to the floor joists. Do
not run flooring parallel to floor joists.
1.3 Flooring may be installed in any direction over a concrete slab.
1.4 Establish a starting point. We recommend the longest exterior running wall.
1.5 Measure the total width of the flooring (including the tongue), plus ½” for expansion. Measure out this
distance in at least 2 places from the starting wall and 12” from the corners. Snap a chalk line parallel to
the starting wall.
Step Two - Lay Out
2.1 Choose the longest and straightest boards and align the plank’s tongue with the working line. Cut the last
plank to the proper length leaving a ¼” from the end wall. Lay out three additional rows, then move these
rows away from the working area
.
2.2 Spread enough adhesive to just cover the area of the first four rows of flooring using the appropriate trowels and
installation technique. Please refer to the adhesive manufacturer’s instructions for application. Never use a “wet-
lay” adhesive, as this could trap moisture under the flooring, causing it to warp.
2.3 Place flooring onto adhesive, one row at a time, making sure that all joints are tight and parallel. Be sure
to use 100-150 lb. weighted roller to ensure complete transfer of adhesive; always protect the floor when
using weighted roller.
2.4 Allow the adhesive to set per the adhesive manufacturer’s recommendation. It is critical to check your
work, making sure the starting row is properly aligned and straight.
Step Three – Rack the Floor
3.1 Once the first four rows are in place, continue to lay out the planks. Remain working from at least four open
cartons. Be sure to blend the planks and stagger the end joints a minimum of 6” apart to ensure a favorable
appearance. Avoid H-Joint and other repeating patterns in the floor.