Owner’s Manual Contents Model Identification............................ 2 Precautions to avoid possible exposure to excessive microwave energy.................... 3 Important safety instructions.... 3 Commercial Microwave Oven Keep these instructions for future reference. If the oven changes ownership, this manual must accompany oven. Installation ......................................... 5 Earthing Instructions.......................... 5 Electronic Control Operation..............
Model Identification When contacting ACP, provide product information. Product information is located on oven serial plate which is located on the back side of the oven. Record the following information: Any questions or to locate an authorized ACP servicer, call toll free 1-866-426-2621 inside the U.S.A or Canada, or 1-319-368-8120 outside the U.S.A or Canada. Warranty service must be performed by an authorized ACP servicer.
IMPORTANT SAFETY INSTRUCTIONS Recognize this symbol as a SAFETY message ! WARNING When using electrical equipment, basic safety precautions should be followed to reduce the risk of burns, electrical shock, fire, or injury to persons. 1. READ all instructions before using equipment. 9. DO NOT heat baby bottles in oven. 2. READ AND FOLLOW the specific “PRECAUTIONS TO AVOID POSSIBLE EXPOSURE TO EXCESSIVE MICROWAVE ENERGY” on this page. 10.
IMPORTANT SAFETY INSTRUCTIONS WARNING WARNING Liquids such as water, coffee, or tea are able to be overheated beyond the boiling point without appearing to be boiling due to surface tension of the liquid. Visible bubbling or boiling when the container is removed from the microwave oven is not always present. THIS COULD RESULT IN VERY HOT LIQUIDS SUDDENLY BOILING OVER WHEN A SPOON OR OTHER UTENSIL IS INSERTED INTO THE LIQUID.
Installation WARNING Unpacking Oven • • • • Inspect oven for damage such as dents in door or inside oven cavity. Report any dents or breakage to source of purchase immediately. Do not attempt to use oven if damaged. Remove all materials from oven interior. If oven has been stored in extremely cold area, wait a few hours before connecting power. Radio Interference Microwave operation may cause interference to radio, television, or a similar oven.
Electronic Control Operation So...how do I use it? 1. Power Up “-- -- ” displays when the oven is powered up for the first time. If Mode. key is pressed, the oven will change to Idle Note: In Idle mode, no key can be pressed. 2. Idle Mode (1) 1)The oven will enter Idle Mode after a set number of seconds have expired in Ready Mode without a keypad pressed or without the door being opened and closed. The default number of seconds is 60 and maybe changed by resetting User Option 4.
Electronic Control Operation 5. Pause Mode (3) If either User Option OP:11 or OP:12 is selected, the oven will continue to sound until the user acknowledges by either opening and closing the door or pressing the 1) This mode allow users to temporarily stop the cooking cycle to inspect or stir the food item. key. User Option OP:10 is the default and after the 3 second beep, the oven will go into Ready Mode.
Electronic Control Operation 6) If X2 is pressed, LED displays “CF:80”. The default factor of 80%. To change the cooking factor, press desired Number Key for new factor. Example: If number “5” key is programmed to cook for 1:00, when first pressing X2 key and then pressing number “5” key, the oven will automatically set the cook time to 1:48. (1:00 cook cycle x 80% “X2” cook factor = 1:48) 7) After setting the time and power, press key to save the cooking program. LED displays “ProG”.
Electronic Control Operation 14. Use Option Mode 1) This allows the user to choose various oven operations. 5) Press key to save the selected setting. LED displays “OP: - -” to indicate selection was saved and another option change can be made. 2) Open the oven door and press Number Key “2” for 5 seconds. The buzzer sounds once to indicate User Option Mode is activated. key to 6) During programming process, press enter Door Open Mode. Close the door will enter Ready Mode. 3) LED displays “OP: - -”.
Dial Operation So...how do I use it? Heating Menu Guide 2:00 :15 1:00-2:00 :45 :30 1:30-2:30 1. Open oven door, place food in oven, and close oven door. 2. Turn time entry knob clockwise to desired time. • Cooking time can be set up to 6 minutes. • Oven begins operation and time counts down. 3. When cooking time has elapsed, microwave energy stops and oven signal sounds. Interrupting Operation Open oven door to interrupt operation or turn time entry knob counterclockwise to “0”.
Care and Cleaning ! WARNING To avoid electrical shock which can cause severe personal injury or death, unplug power cord or open circuit breaker to oven before cleaning or removing light bulb. DO NOT power spray PART No metal pans CARE AND CLEANING RECOMMENDATION Interior, Exterior, and Door Clean microwave oven with mild detergent in warm water using soft sponge or cloth. Wring sponge or cloth to remove excess water before wiping equipment.
Before Calling for Service ! WARNING To avoid electrical shock which can cause severe personal injury or death, do not remove outer case at any time. Only an authorized ACP servicer should remove outer case. Troubleshooting Complaint Dim oven light Steam forms on oven door Hot air expelled from vents Oven does not start. Possible Cause Cooking at low power level. When cooking foods in a microwave steam is generated. Foods cooking in a microwave may release heat. Power cord not plugged in correctly.
