Service manual

Chapter 3 E40S/E60S Disassembly and assembly
FileStore Service Manual 92
Figure 8: Rear plastic removal
(7) Remove the hard disc drive (Item 40).
 The drive stands off the base on four pillars (Item 8). To remove the drive along with the
pillars from the base metalwork, turn the FileStore unit on its side.
 Support the drive while unscrewing the four Posidriv screws (Item 61).
 Remove the two ribbon cable assemblies, earth wire and power cable from the rear of the
hard disc drive.
 The mounting pillars can then be unscrewed. After the drive has been removed, ensure
that it is still kept free of static discharges.
(8) Remove Power Supply (Item 38).
 The upper surface of the psu is covered by a insulating material (Item 25) fixed by four
Posidriv screws (Item 62) to the psu. Unscrew these four screws and remove the insulator.
 Between the insulator and the psu are four small plastic spacers (Item 11) used to ensure
the pcb does not pierce the insulator. Remove these.
 The psu is now held by various cable assemblies. Unplug the 13 way cable assembly
(Item 34). It should now be possible to unplug the mains cable assembly (Item 10) from
the component side of the psu. The Earth wire is fixed by a faston receptacle which can
be pulled clear.