User guide

Dir full

A user has tried to create a file in a directory which is full ie contains 63

entries already. Use another directory or delete one of the files in the

directory, first.

Dir not empty

A user has tried to delete a directory by using the

*DELETE

command, but

the directory still contains some entries. Delete the entries first.

Disc changed

A user has tried to use a disc after FileStore has been shut down then started

up again (for example, so that the manager could change a disc). They

should log on again or select a disc by using the

*SDISC

command.

Disc fault

FileStore cannot read this disc, because it is damaged or not formatted. If the

disc is damaged, destroy it and use a backup. If the disc is unformatted,

format it. If the disc affected is the hard disc, contact your supplier.

Disc full

You've tried to use more space than is left on the current disc. Make room by

deleting unwanted files or use a different disc.

Disc read only

A user has tried to create or change a file on a disc which has been

write-protected. To allow them to write to the disc, you will need to remove

the disc, pull its write-protect tab out, then insert the disc again.

Entry locked

A user has tried to change or delete a file which has the L attribute set (see

Security and access

in Chapter 3). If they want to be able to change it, they

must remove this attribute by using the

*ACCESS

command. They will only

be able to do so if they 'own' the file. (If you log on as SYST you can do it for

them, too. )

EOF

Program error.

Appendix

DEALING WITH PROBELMS

