User guide

7.
Type:
*FSUSER name
where name is the new id you've invented.
8.
Make sure you remember the new maintenance id.
If you are adding a printer, carry on with the next stage now.
If you are not adding a printer:
1. Type:
*FSMODE U
I  I
to return FileStore to user mode.
2. Type I  I to return to the main menu.
3. FileStore is now ready for use. If you are not going to allow users to start
using it yet, turn it off.
Adding a printer 
If you are adding a printer to Econet, there are a few more steps you should
take, as follows.
Checking the printer
To check that the printer works, proceed as follows:
1.
Select the main menu on your Communicator (eg press
I STOP I) and start
up the Configure task.
2. Select a PRINTER type of ECONET.
3.
Select an ECONET PRINTER name of PRINT (or the name you've set
by using the *PRNAME
command).
4.
Press SAVE to store the new configuration.
5. Press I STOP I to return to the main menu.
6.
Check that the printer is ready ie turned on and has paper and ribbon
inserted.
7. Press PRINT. This should print the current screen on the printer.
Refer to Appendix 2 if the printer does not work.
56
 Appendix 1: INSTALLING FILESTORE