User guide

2. Open the access flap, then turn FileStore on. (This puts FileStore into
its maintenance mode.)
3.
On your Communicator, press I STOP I
to select the main menu, then press
LOG ON .
4.
Type:
SYST
in reply to the prompt:
User name :
and I 
I in reply to the prompt:
Password :
(This logs you on to FileStore in maintenance mode. SYST is the
FileStore maintenance id, which you will change later, to prevent
unauthorised access.)
5.
Select BASIC from the main menu, then type:
*FSSTN nnn
*FS
n I

I
where
nnn
is the new station number. Your screen should display the
message:
FileStore station number now nnn
If a different message is displayed or no message is displayed within a
minute, check what to do next by referring to Appendix 2.
6.
Turn FileStore off.
Optimising  The steps described here are not essential but may improve the performance
performance 
of FileStore.
As supplied, FileStore will allow up to 80 users to be logged on at a time. If
the number of users who will be using FileStore at one time is much smaller
than this, you can make FileStore run a little faster by doing the following:
1. Turn FileStore on with its access flap open. On your Communicator,
press I STOP I to select the main menu and then press LOGON.
Appendix 1: INSTALLING FILESTORE 
49