User guide

10.

The prompt

should change to:

Pathname, destination file/directory

Type:

:Library

disc.$

11.

The prompt should now change to:

Press F6 to adjust the DATE range

Press Fl again to proceed with the COPY

Press ESCAPE to abort action

12.

Press COPY. Both disc drives should start working, as shown by their

drive activity lights and the screen should show the name of each

file/directory as it is copied.

13.

After a few minutes, the disc drives should stop and the initial

NETMGR screen should be displayed, indicating that copying is

complete.

14.

Open the access flap and remove both discs from the drives by pressing

their eject buttons. Put the Master library disc away in a safe place.

Write today's date on the Library disc you've just created. You will use

this to run FileStore.

your Econet



If there is already a FileStore unit on the Econet, you must make sure that the

already has a



FileStore you are adding do not interfere with each other, as follows.

FileStore



Each unit (Communicator or FileStore) connected to Econet is identified by

a unique number, in the range 1 to 254 which is called its 'station number'.

Whenever you add a unit to Econet, you must make sure that its station

number is different to all the other units' station numbers.

Check the station number(s) of the other FileStore unit(s). These should

have been written down by whoever installed them.

FileStore is delivered to you with a station number of 254. If this is already

used, you should change it to the next smallest number which is not being

used, as follows:

1. Check that FileStore is turned off. Check that any other FileStores

connected to Econet are turned off, too, or (if this is not convenient),

connect FileStore directly to a Communicator using the Econet lead.



Appendix 1: INSTALLING FILESTORE