User guide

9.
After a short while, the disc drive should stop working and its indicator
should go out. On your Communicator screen, you should see the
message Disc formatted. If you see a different message or no message is
displayed after 5 minutes, check what to do next by referring to
Appendix 2.
10.
Remove the disc by pressing the disc drive eject button. Write the disc's
title (in this case, library-disc') on the disc's label, to help you tell that
it's ready for use.
You only need one formatted disc at the moment, to get FileStore ready.
However, you will need several more once you start using FileStore, so it's a
good idea to format a few more (at least 4 more) if you have more blank discs.
To format more discs, just repeat steps 4 to 10 for each one, but instead of a
title of library-disc', use 'Work l', Work2', etc.
Copy ing
pying the Master
Supplied with FileStore is a floppy disc, the Master library disc, which
lib  disc 
contains information and programs that FileStore and FileStore users need.
This disc is very important, as without it, FileStore won't function properly.
To protect you against the (unlikely) event of this disc being damaged, you
should take at least one copy of it and put the original disc away in a safe
place. You can then use one of the copies, safe in the knowledge that if
something should go wrong, you'll only lose a copy of these programs, not the
programs themselves.
NOTE: You may be instructed to ignore this stage, if someone else has
already copied this disc for you or you have a hard disc unit.
To copy the Master library disc, proceed as follows:
1.
Check that FileStore is turned off.
2.
Slide the write-protect lock on the Master disc to the SAFE position,
then insert the disc in the lefthand drive.
3.
Put the disc that you've just formatted (with the title library-disc') in
the righthand drive.
4.
Close the access flap.
5.
Turn FileStore on and wait until the disc activity lights stop (about one
minute).
46 
Appendix 1: INSTALLING FILESTORE