User guide

3
MANAGEMENT FACILITIES
Introduction 
This chapter describes how to manage FileStore, once it has been installed.
You are advised to read Chapter 2 first, as that explains many of the terms
used in this chapter and gives you a good idea of the context that you're
working in.
Your facilities 
As FileStore manager, you have access to three main sets of facilities:
—
Commands issued when FileStore is running normally.
—
NETMGR commands, available only to you (and other privileged users)
while FileStore is running normally.
—
Maintenance mode commands, available only to you (and other
priviledged users) while FileStore is running in maintenance mode.
A full list of these commands is contained in Appendix 3.
To perform any of the tasks described in the following pages, you must first
select the correct mode (normal, NETMGR, maintenance).
For normal mode, see Starting up. NETMGR and maintenance modes are
described below:
Selecting 
To select NETMGR:
NETMGR

1.
Make sure FileStore is running in normal mode (see Starting up).
2. Select the Communicator main menu (press I stop I).
3.
Press the LOGON key.
4.
In reply to the prompt:
User name
Type:
SYST
5.
In reply to the prompt:
Password
3 MANAGEMENT FACILITIES
 11