Service manual

Service Manual
Appendix A - Mouse test jig template
You can use the template above as a test jig, but take care
that the mouse does not slip on the paper. You can
construct a better jig as follows:
1 Using wood or metal strips, construct a test jig with the
dimensions shown in the template (plan view) above.
2 Secure the test jig to a firm, flat, horizontal, non-slip
surface.
3 Mark out the three button boxes shown on the template.
Notes:
• The }NS}DE dimensions of the jig are important.
• The sides of the jig should be LESS than 5mm high.
• The Middle and Right button boxes overlap.
Appendix A - Mouse test jig template Issue 2, June 1991 A-1