Service manual

A5000 Module Level Service Manual
Appendix A - Mouse test jig template
1 Using wood or metal strips, construct a test jig with the
dimensions shown in the template (plan view) above.
2 Secure the test jig to a firm, flat, horizontal, non-slip
surface.
3 Mark out the three button boxes shown on the
template.
Notes:
• The INSIDE dimensions of the jig are important.
• The sides of the jig should be LESS than 5mm high.
• The Middle and Right button boxes overlap.
Mouse in middle
button box
Appendix A - Mouse test jig template Issue 1, November 1991 A-1