Installation Guide

Extending the output wires of the solar panel
Figure 1 Charge controller connected to a 12V battery
Fig.2. MC4 Adapter Kit
Before starting the connection, keep in mind the following:
• The charge controller should be as close as possible to the batteries. This helps
keep line loss to a minimum level.
• Remember to always use the recommended gauge size based on the PV system
and charge controller.
The battery must first be wired to the charge controller before the solar panel is
connected to the charge controller.
Email: [e-mail] Call: [phone] Web:www.acopower.com
Address:4120 Valley Blvd, Walnut CA 91789, USA
1 2 3 4 5 6 7 8 9
10 11 12 13 14 15 16