Installation guide
Table Of Contents
- Table of Contents
- Introduction
- Unpacking and Installing the Switch
- Connecting the Switch to the Network
- Maintenance
- Removing a Hard Disk
- Index
Before You Begin
ARX-1000 Hardware Installation Guide A - 43
Before You Begin
When returning a disk drive, power supply, or the whole ARX, you must
send along the serial number for the chassis. In some cases, you also need
the base MAC address for the chassis.
Use the show chassis command to get the serial number. If you cannot
reach the CLI, read the serial number on the front, right-hand side of the
chassis (under the cooling holes).
See the following example output for the show chassis command.
gffstnA# show chassis
Identification:
Hostname UUID
------------------------------------ --------------------------------------
gffstnA e5d870ae-571e-1352-916b-ef324fbc05a2
Chassis:
Chassis Type Model Number HW Ver. Serial Number
------------ ------------------------------------ ------- -------------
ARX-1000+ ARX1 B 09 03002160
Private Subnet:
VLAN Subnet Subnet Mask
---- ---------------- ----------------
1004 169.254.3.0 255.255.255.0
Chassis Environment:
Base MAC Address Power Chassis Revision
----------------- -------------- ----------------
00:0a:49:08:70:00 Online 03 25
Logical Disk Details:
Disk Status Verification Mode Verification Rate
------ --------------------- ----------------- -----------------
1 Optimal Automatic 10 %
Disk Details:
Disk Size State Transfer Rate Model
-------- ----------- ----------------- ------------- -----------------
Bay 1 69.24G Online 1.5Gb/sec WD740GD-00FLC0
Bay 2 69.24G Online 1.5Gb/sec WD740GD-00FLC0