Installation guide

Chapter 4
Maintenance
4 - 38
LED Status Indicators
This section describes the ARX-1000’s status LEDs, including:
• System Alert and module Status LEDs
• Hard-drive LED and NVR-battery-backup LEDs (also shown in
• Ethernet management port and user port LEDs (see Figure 7.4 on
page 7-6)
Figure 4.3 ARX-1000 System LEDs
Figure 4.4 ARX-1000 Port LEDs
Status LEDs
The ARX-1000 front panel provides the following LED status indicators:
• ALERT — Illuminates Red to indicate an operational failure
• STATUS — Illuminates Green or Yellow based on the system’s current
operational state
system Alert (red
if hardware fails)
module Status
(green = ’all OK’,
yellow = ’at least
one failed’)
Hard Disk
activity (not
supported)
yellow when NVR
powered by backup
battery
each port has one Activity LED (yellow) and one Link LED (green)