Installation guide

Chapter 3
Connecting the Switch to the Network
3 - 32
Connecting the Ethernet Management Port
After you boot the switch, you can connect the Ethernet out-of-band
management port to a management station or network. You can use this
interface to access the Graphical User Interface (GUI) or the Command Line
Interface (CLI). To access the GUI, direct a web browser to the interface
over HTTPS (for example, “https://10.1.49.60/”). Use the crypto-officer
username and password, entered above, to log in. For the CLI, use SSH with
the interface and the crypto-officer username (for example, “ssh
admin@10.1.49.60”).
The ARX GUI Quick Start: Network Setup manual contains instructions for
getting started with the GUI, and the ARX
®
CLI Network-Management
Guide contains instructions and best practices for using the CLI.