Installation guide
Manuals
Brands
acopla Manuals
Computer equipment
ARX 1000
21
22
23
24
25
26
27
28
29
30
Table Of Contents
Table of Contents
Introduction
Audience for this Manual
Document Conventions
Related Documents
Safety and Regulatory Notices
Class A ITE Label
Qualified Personnel Warning
Environmental
High Temperature Warning
Restricted Area Warning
Warning for Rack-Mounting and Servicing
Power
International Power Cord Requirements
Power Cord Usage
Electric Shock Warning
SELV Circuit Warning
Circuit Breaker (15A)
Power Supply Disconnection Warning
Battery Handling Warning
Contacting Customer Service
Unpacking and Installing the Switch
Safety Instructions
Tools and Equipment
Verifying Shipment
Unpacking the Switch
Installing the Rack-Mount Rails
Rack-Mounting the Switch
Attaching the Power Cord
Powering Up the Switch
Cabling
Connecting the Switch to the Network
Management Interfaces
Connecting the Console Port
Booting the Switch
Sample: Booting a Non-Replacement Switch
Preparing for Switch Replacement
Choosing Switch Replacement
Matching the Private Subnet
Entering the Private Subnet
Finding the UUID of the Failed Switch
Applying the UUID
Installing a Redundant Peer or Cluster
Applying the Master Key
Sample: Replacing a Redundant Peer
Connecting the Ethernet Management Port
Maintenance
Powering Down the ARX-1000
POST Diagnostics
LED Status Indicators
Status LEDs
Ethernet-Port Link Status LEDs
Hard-Drive (HD) LED
Removing a Hard Disk
Before You Begin
Removing the Drive
Silencing the RAID Alarm
Replacing the Disk Drive
Incorporating the Disk into the RAID
Monitoring the Rebuild
Index
3
Connecting the Switch to the Network
This chapter describes how to connect the ARX to a console terminal and
boot the switch for the first tim
e. It contains the following sectio
ns:
•
Management Interfaces
•
Connecting the Console Port
• Booting the Switch
•
Connecting the Ethern
et Management Port
1
...
...
27
28
29
30
31
...
...
60
