Installation guide

SFP Optical Connector
ARX
®
6000 Hardware Installation Guide A - 5
SFP Optical Connector
The Network Services Module (NSM) optical version uses small
form-factor pluggable (SFP) optical connectors for connection to Ethernet
over fiber-optic cable.
Figure A.3
shows an example SFP connector.
Figure A.3 SFP Optical Connector
WARNING
Fiber-optic ports are shipped with cable connectors installed. These ports
must be protected by a rubber grommet filler or a cable connector at all
times to prevent dust from collecting in the transceiver.
GND 4 green 5 5 green 5 Signal
Ground
GND 5 red 4 4 red
RxD 6 black 3 3 black 3 TxD
SCM/ACM
Console Port
RJ-45 Rollover Cable RJ-45 to DB9 Adapter
Console
Device
Table A.2 SCM Console Port Signaling/Cabling Using a Rollover Cable (Continued)