Installation guide

Chapter 7
Connecting the Switch to the Network
7 - 14
See the ARX® CLI Network-Management Guide for detailed configuration
instructions.
Connecting the Ethernet Management Port
After you boot the switch, you can connect the Ethernet out-of-band
management port on the SCM to a management station or network. You can
use this interface to access the Graphical User Interface (GUI) or the
Command Line Interface (CLI). To access the GUI, direct a web browser to
the interface over HTTPS (for example, “https://10.1.27.69/”). Use the
crypto-officer username and password, entered above, to log in. For the CLI,
use SSH with the interface and the crypto-officer username (for example,
“ssh admin@10.1.27.69”).
The ARX
®
GUI Quick Start: Network Setup manual contains instructions for
getting started with the GUI, and the ARX® CLI Network-Management
Guide contains instructions and best practices for using the CLI to set up the
ARX
®
.