Installation guide

Chapter 6
Unpacking and Installing the Chassis
6 - 14
Figure 6.8 shows the air filter and cable guide location on the bottom front
of the chassis.
Figure 6.8 Air Filter/Cable Guide Location
Installing the Air-Filter Panel and Cable Guide
WARNING
Customers are required to maintain the switch’s air filter at regular
intervals. Failure to do so may damage the switch.
To install the air-filter panel/cable guide:
1. Remove the air-filter front panel/cable guide from the accessory kit.
2. Remove the tape from the air filter opening and verify the air filter
is seated properly in the chassis.
3. Insert the cable guide into the opening, aligning the captive screws
on either side with the holes in the chassis.
4. Hold one side while tightening the screw on the opposite side; then
tighten the other screw to secure the cable guide in place.
Air filter and cable guide location