Installation guide

Chapter 6
Unpacking and Installing the Chassis
6 - 8
Power Supply A (the top one) corresponds to the power plug labeled
“Primary” on the back panel. Power Supply B corresponds to the plug
labeled “Redundant” on the back panel.
1. In the utility bay, remove a power supply by carefully inserting a
flat-head screwdriver into the center notch and pulling up and out.
The power supply handle will release toward you.
Figure 6.3 Removing the Power Supply
WARNING
Do not put excessive strain on the handle. Do not lift or carry the power
supply by its handle.
2. Carefully slide the power supply out of the bay and set aside.
3. If there is a redundant power supply, repeat these steps to remove
the other power supply.
handle-release notch
pull
handle
slowly