Installation guide

Safety Instructions
ARX
®
6000 Hardware Installation Guide 6 - 3
Safety Instructions
Observe the following safety guidelines to avoid personal injury or damage
to equipment when installing or operating the switch:
DANGER
The chassis is both heavy and difficult to maneuver. Two or more people are
required to move and lift the chassis.
DANGER
Never assume that power is disconnected from a circuit; always check.
Before installing the switch, locate the power ON/OFF toggle on the back of
the chassis and make sure it is set to OFF.
Disconnect any power or external cables before moving a chassis.
A chassis configured with two power supplies has two power cords. In the
event that AC power must be removed from the system, disconnect both
power cords before servicing the unit to avoid electric shock.
Required Tools and Equipment
The following equipment is required/recommended for unpacking,
rack-mounting, and installing the chassis:
• pallet jack or handcart
• Wire cutter/utility knife
• Rack-mount screws
• #2 Phillips screwdriver
• Flat-head screwdriver
• Data cables (see Power Cord and Cable Requirements
, on page 5-5)
• Customer-supplied standard 19-inch EIA rack
• Antistatic wrist straps for handling modules