Installation guide

Removing a Hard Disk
Silencing the RAID Alarm
A-2 ARX®1000 Hardware Installation Guide
To remove a disk drive, use a Phillips-head screwdriver to loosen both captive screws.
Slide out the disk drive and sled from its slot in the chassis.
The chassis continues to run, in degraded state, with only one disk missing from the
RAID.
Silencing the RAID Alarm
After you remove the drive, an audible alarm goes off to signal that the drive is
missing. From the CLI (priv-exec mode), you can use the
raid silence command to
quiet this alarm:
raid silence
For example, the following command sequence logs into a switch at 10.1.23.11,
enters
enable to go to priv-exec mode, and silences the RAID alarm:
$ telnet 10.1.23.11
Trying 10.1.23.11...
Connected to 10.1.23.11.