Installation guide

Operational Status and Troubleshooting
LED Status Indicators
7-6 ARX®1000 Hardware Installation Guide
STATUS — Illuminates Green or Yellow based on the system’s current operational
state
During various module operations, LEDs display Green, Yellow, or Red with
intermittent blinking patterns, depending on the state. When blinking, LEDs blink ON
for a half second and OFF for a half second.
Table 7-1 describes the LED colors and blinking patterns that occur during various
operational states, such as booting, diagnostics (pass/fail), and so on.
Ethernet-Port Link Status LEDs
The Ethernet ports on the ARX®1000, the MGMT port and the client/server ports,
each have two LEDs in their upper corners:
• Upper left – Activity LED: blinking yellow indicates packet traffic.
• Upper right – Link-status LED: steady green indicates that the port is enabled and
a link is established.
Table 7-1. Operational States and LED Patterns
ALERT STATUS State
(Off) Green Online
Red Green (Blinking) Failed or powering down
(Off) Yellow (Blinking) Powering up and running all POST tests.
(Off) Yellow Online Partial: at least one processor is online, at least one is not
online yet.
If the offline processor does not come up in 5 minutes, this
changes to Failed Partial.
Red Yellow Failed Partial: at least one processor is online, but at least one
other processor failed.
(Off) (Off) Power Failure