Installation guide

Connecting the Switch to the Network
Connecting the Ethernet Management Port
6-16 ARX®1000 Hardware Installation Guide
prtlndA1k(cfg)# ...
prtlndA1k(cfg)# exit
prtlndA1k#
If you copied the private subnet and mask from the defunct switch, this completes the
switch replacement. Otherwise, the new switch learns its private subnet from its peer,
re-configures itself, and reboots. (A reboot is necessary to change the private subnet
of an ARX.)
See the CLI Network-Management Guide for detailed configuration instructions.
Connecting the Ethernet Management Port
After you boot the switch, you can connect the Ethernet out-of-band management port
to a management station or network. You can use this interface to access the
Graphical User Interface (GUI) or the Command Line Interface (CLI). To access the
GUI, direct a web browser to the interface over HTTPS (for example,
“https://10.1.23.11/”). Use the crypto-officer username and password, entered above,
to log in. For the CLI, use SSH with the interface and the crypto-officer username (for
example, “ssh admin@10.1.23.11”).
The GUI Quick Start: Network Setup manual contains instructions for getting started
with the GUI, and the CLI Network-Management Guide contains instructions and best
practices for using the CLI to manage the ARX.