Installation guide

Connecting the Switch to the Network
Booting the Switch
6-12 ARX®1000 Hardware Installation Guide
Acknowledge acceptance of the following terms and conditions
by entering 'yes' at the next question.
1. Press <Enter> to continue. # <Enter>
...
2. Enter 'yes' to accept these terms and conditions
in the format 'yes' or 'no'. # yes
The switch's management port requires an IP address and mask.
3. Enter the management port IP address
in the format nnn.nnn.nnn.nnn or 'none'. # 10.1.23.12
4. Enter the management port subnet mask
in the format nnn.nnn.nnn.nnn.(default=255.0.0.0) # 255.255.255.0
The switch's management port requires a gateway IP address.
5. Enter the gateway IP address for the management interface
in the format nnn.nnn.nnn.nnn or 'none'. # 10.1.23.1
This next question invokes the questions for switch replacement:
A switch replacement requires additional configuration questions.
6. Are you doing a switch replacement?
in the format 'yes' or 'no'.(default=no) # yes
The switch's internal subnet requires an IP address and mask.
7. Enter the switch's private IP address
in the format nnn.nnn.nnn.nnn.(default=169.254.52.0) # 169.254.94.0
8. Enter the switch's private subnet mask
in the format nnn.nnn.nnn.nnn.(default=255.255.255.0) # <Enter>
The private subnet VLAN is used externally for redundancy traffic.
Be sure this value does not conflict with existing VLAN IDs.
9. Enter the chassis's private subnet VLAN
in the format integer [1-4095].(default=1002) # <Enter>