Installation guide

Connecting the Switch to the Network
Booting the Switch
ARX®1000 Hardware Installation Guide 6-3
Sample: Booting a Non-Replacement Switch
This sample shows the simplest initial-boot scenario, for a new (non-replacement)
switch that is either standalone or the first member of a redundant pair. The sample
answers are not necessarily appropriate to the following scenarios:
• this replaces a defunct switch,
• this will join a running switch as its redundant peer, or
• this switch is being re-installed after Acopia personnel performed a
“Manufacturing Installation” on a previously-running switch.
Later sections discuss these contingencies and how to handle each of them. The
answers below apply to the simplest case only. Sample answers are shown in bold
text:
Acopia Switch Startup
This Acopia switch does not currently have critical system
information programmed. The following wizard prompts you
for this information. You can connect to the switch through
the out-of-band management interface when you finish.
To restart the configuration program, enter 'r' at any prompt.
Acknowledge acceptance of the following terms and conditions
by entering 'yes' at the next question.
1. Press <Enter> to continue. # <Enter>
LICENSE AGREEMENT
This is a legal agreement between the end user (“You”) and Acopia
Networks, Inc., a Delaware corporation with its principal office
...
applicable federal or state courts located in the Commonwealth of