Installation guide

Introduction
Safety and Regulatory Notices
1-8 ARX®1000 Hardware Installation Guide
Circuit Breaker (15A)
Power Supply Disconnection Warning
Battery Handling Warning
Les ports étiquetés LINK, 1/1 through 1/6, CONSOLE, MGMT, MIRROR, et DEBUG
sont des circuits de sécurité basse tension (safety extra-low voltage ou SELV). Les
circuits SELV ne doivent être interconnectés qu'avec d'autres circuits SELV.
!
ATTENTION
!
WARNING
This product relies on the building's installation for short-circuit (overcurrent)
protection. Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240
VAC, 10A international) is used on the phase conductors (all current-carrying
conductors).
Pour ce qui est de la protection contre les courts-circuits (surtension), ce produit dépend
de l'installation électrique du local. Vérifier qu'un fusible ou qu'un disjoncteur de 120 V
alt., 15 A U.S. maximum (240 V alt., 10 A international) est utilisé sur les conducteurs
de phase (conducteurs de charge).
!
ATTENTION
!
WARNING
Before working on a chassis or working near power supplies, unplug the power cord on
AC units.
Avant de travailler sur un châssis ou à proximité d'une alimentation électrique,
débrancher lecordon d'alimentation des unités en courant.
!
ATTENTION
!
WARNING
There is the danger of explosion if the battery is replaced incorrectly. Replace the
battery only with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.