Installation guide

Introduction
Safety and Regulatory Notices
ARX®1000 Hardware Installation Guide 1-7
Power
Power Cord Usage
Electric Shock Warning
SELV Circuit Warning
!
WARNI
Do not use the attached power supply cable for other devices or usage.
The attached power supply cable was designed to be connected and to be used for Acopia
devices, and the safety for this purpose has been confirmed.
Please do not use it for other devices or usages. There may be danger of causing a fire or
an electric shock.
注意－添付の電源コ?ドを他の? 置や用途に使用しない
添付の電源コ?ドは本? 置に接? し、使用することを目的に設計され、その安全性が確認
されているものです。決して他の? 置や用途に使用しないで下さい。火災や感電の原因と
なる恐れがあります。
!
WARNING
This unit might have more than one power cord. To reduce the risk of electric shock,
disconnect the two power supply cords before servicing the unit.
Il est possible que cette unité soit munie de plusieurs cordons d'alimentation. Pour
éviter les risques d'électrocution, débrancher les deux cordons d'alimentation avant de
réparer l'unité.
!
ATTENTION
!
WARNING
The ports labeled LINK, 1/1 through 1/6, CONSOLE, MGMT, MIRROR, and DEBUG
are safety extra-low voltage (SELV) circuits. SELV circuits should only be connected to
other SELV circuits.