Installation manual

Policy for Balancing Capacity
Creating a Schedule
CLI Storage-Management Guide 12-31
Showing One Schedule
To focus on a single schedule, add the desired schedule name to the command:
show policy schedule name
where name (1-64 characters) identifies the schedule to show.
For example, this shows the “hourly” schedule:
bstnA6k(gbl)# show policy schedule hourly
Schedule: hourly
Start Time: Sun Oct 24 01:00:00 2004
Previous Run: Wed Apr 4 05:00:00 2007
Runs Next: Wed Apr 4 06:00:00 2007
Interval: 1 hours
bstnA6k(gbl)# ...
Removing a Schedule
Use the no form of the schedule command to remove a schedule from the switch
configuration:
no schedule name
where name (1-64 characters) identifies the schedule to be removed.
For example, the following command sequence shows all schedules and deletes the
schedule named “daily4am:”
bstnA6k(gbl)# show policy schedule
Schedule: hourly
Start Time: Sun Oct 24 01:00:00 2004
Previous Run: Wed Apr 4 05:00:00 2007
Runs Next: Wed Apr 4 06:00:00 2007
Interval: 1 hours
Schedule: daily4am