Installation manual

Adding a Managed Volume
Adding a Share
9-42 CLI Storage-Management Guide
The CLI prompts for confirmation before taking ownership of the share. Enter yes to
proceed.
For example, the following command sequence enables the
“insur_bkup~/insurShdw~backInsur” share, taking ownership of the share if
necessary:
prtlndA1k(gbl)# namespace insur_bkup
prtlndA1k(gbl-ns[insur_bkup])# volume /insurShdw
prtlndA1k(gbl-ns-vol[insur_bkup~/insurShdw])# share backInsur
prtlndA1k(gbl-ns-vol-shr[insur_bkup~/insurShdw~backInsur])# enable take-ownership
This command allows the switch to virtualize shares that are used by other Acopia switches.
Allow switch to take ownership of share? [yes/no] yes
prtlndA1k(gbl-ns-vol-shr[insur_bkup~/insurShdw~backInsur])# ...
Examining the shareEnableSubshareInc Report (CIFS)
This only applies to CIFS volumes where filer-subshares is enabled; recall
“Supporting Subshares and their ACLs” on page 9-20. Skip this section unless this
option is active in the volume.
Whenever you enable a share in such a CIFS volume, the volume generates a report
on all subshare-related activity. The CLI shows the name of the report after you issue
the
enable command. For example:
bstnA6k(gbl)# namespace medarcv
bstnA6k(gbl-ns[medarcv])# volume /rcrds
bstnA6k(gbl-ns-vol[medarcv~/rcrds])# share charts
bstnA6k(gbl-ns-vol-shr[medarcv~/rcrds~charts])# enable
% INFO: Successfully replicated all consistent back-end subshares to 'charts'. See report
'shareEnableSubshareInc_200612201446.rpt' for details.
bstnA6k(gbl-ns-vol-shr[medarcv~/rcrds~charts])# ...
This report shows the progress of any replications or subshare-consistency checks that
the volume performed. Use the
show reports report-name command to view the
report. For example, this shows the report from the above share-enable command:
bstnA6k(gbl-ns-vol-shr[medarcv~/rcrds~charts])# show reports
shareEnableSubshareInc_200612201446.rpt
**** Share Enable Filer-Subshare Inconsistency Report: Started at Wed Dec 20 14:46:50 2006
****
**** Software Version: 2.05.000.09900 (Dec 19 2006 17:39:42) [nbuilds]
**** Hardware Platform: ARX-6000