Specifications

Accessory Decoder LS 100/110 17
DIGITAL plus
The pulse duration is determined by the following values:
value
pulse duration
(seconds)
value
pulse duration
(seconds)
0 0.1 8 2.0
1 0.2 9 3.0
2 0.3 10 4.0
3 0.5 11 6.0
4 0.6 12 8.0
5 0.8 13 10
6 1.0 14 12
7 1.5 15 15
Table 3: Setting pulse duration
The flashing rate is determined by the following values:
Value flashing rate (Hz) Value flashing rate (Hz)
33 4 41 2.0
34 3.75 42 1.75
35 3.5 43 1.5
36 3.25 44 1.25
37 3.0 45 1.0
38 2.75 46 0.75
39 2.5 47 0.5
40 2.25
Table 4: Setting the flashing rate
The decoder version number is contained in R7. R8 contains the
manufacturer ID, which for Lenz Elektronik is 99. Both registers
can only be read, and can not be overwritten.
Connecting the LS100/LS110 to the programming output of
a command station
When the accessory decoder is to be programmed using the
programming output of the command station, we recommend
that you do all the programming before installation. For the
command station to be able to recognize successful
programming, please connect a turnout motor or a lightbulb (not
an LED!) to an output that is not set to constant on or flashing
operation. If you do not do this, you will get an error message
“ERR02” (decoder not found) on the LH100.