User's Manual

5.5. FCC AND IC
5.5.1. Numéros d'agrément
Table 10: FCC and IC IDs for Eagle devices
Item
Model
FCC ID (USA)
IC (Canada)
Gateway (Int. Antenna)
EGL1101000
2AC3Z-EGL1101
12336A- EGL1101
Gateway (Ext. Antenna)
EGL1105000
Single Axis Sensor
EGL1102000
2AC3Z-EGL1102
12336A-EGL1102
Tri Axis Sensor
EGL1103000
Expander
EGL1104000
Attention: tout changement ou modification non expressément approuvés par la
partie responsable de la conformité pourraient annuler l'autorité de l'utilisateur à
utiliser l'équipement.
5.5.2. NOTES FCC:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instruction, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception which can be determined by
turning the equipment off and on, the user is encouraged to try to correct interference
by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on circuit different from that to which the
receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
RF exposure: This device complies with FCC RF radiation exposure limits set forth for
general population. This device must be installed to provide a separation distance of
at least 20cm from all persons and must not be co-located or operating in conjunction
with any other antenna or transmitter.
5.5.3. NOTES IC:
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé
pour l'émetteur par Industrie Canada. Dans le but de réduire les risques de brouillage
radioélectrique à l'intention des autres utilisateurs, il faut choisir le type d'antenne et
son gain de sorte que la puissance isotrope rayonnée équivalente (p.i.r.e.) ne dépasse
pas l'intensité nécessaire à l'établissement d'une communication satisfaisante.
 L'antenne des capteurs et répéteurs est interne et non interchangeable.
 L'antenne de la Gateway EGL1101000 est interne et non interchangeable.
 La Gateway EGL110500 peut être équipé de l'antenne externe suivante:
 "iANT212 Omni Directional WiFi Rugged Antenna se Extronics"