User's Manual

Brand of ACOEM

4.2.1.

Direct mounting

See Figure 25

Ensure a flat surface: remove paint layers. Step 1.

NOTE: if you use a spot facing tool be sure to not exceed 0.8mm depth [0.031 in].

Drill a hole (Ø5 mm and XXmm depth [Ø 0.19 in - ) Step 2.

Thread the hole with M6 tap Step 3.

Screw M6 stud with a length of XXmm Step 4.

CAUTION: The part of the stud inserted into the sensor can be up to 6 mm

[0.23 in]. A bottoming stud may cause base-strain and also potentially damage

electronics.

Screw the sensor on the stud and tighten at 5 - 7 Nm [44 - 62 inch-lb] using the Step 5.

dedicated tube wrench and your handgrip.

NOTE: for a better contact a film of grease/oil can be applied between sensor and

mounting surface (note the oil/grease must be compatible with the temperature of

the measurement point).

CAUTION: If you use a 44mm wrench [1.73 in] or an adjustable wrench be careful

to observe the indicated torque range.

Fill in the installation report with sensor information (S/N, type, location, Step 6.

orientation…)

Figure 25: direct mounting with M6 stud

Figure 26: spotface mounting