User's Manual

21
Brand of ACOEM
Figure 19 : cable, gland and connector assembled
3.4. CONNECTION TO THE POE
Attention le POE doit être hors zone ATEX.
The PoE is preferably located close to the gateway (sauf en zone ATEX)but can be located
at 100m max (Ethernet limitations).
Manage cables by using different colors to differentiate PoE from LAN.
Define a standard that is relevant to your requirements or the one in application in your
company.
 Blue or Grey for Network (LAN)
 Yellow or Red for PoE
Be careful when connecting.
Check twice that “PoE” port is connected with the gateway.
Wrong connections may cause damages
Connect the ethernet cable from the gateway to the PoE injector on the "PoE" Port. Step 1.
Connect "LAN" port of the PoE to the IP network. Step 2.
Check your connections Step 3.
Power the PoE using the appropriate power plug for your country. Step 4.
Figure 20 : PoE connection instructions
PoE (LAN+DC)
LAN
GATEWAY
IP NETWORK
POWER
110-240 V
50-60 Hz
C13
48 V - 0.5 A