User's Manual

19
Brand of ACOEM
3.2. MOUNT
A damp cloth should be used when installing or taking off the gateway in hazardous areas to
eliminate static electricity resulting from this operation.
The gateway is fixed very quickly on a pole or on a wall using a ball-joint mount
(EGL1208000).
The ball-joint mount is constituted of:
 A ball-joint head
Fixed on the bottom of the gateway using M8 screw and bolt.
 A ball-joint base
The base is to be pegged on a wall or on a pole.
 The mounting on a pole requires a clamp, nuts and washers.
 The mounting on a wall is done using four screws and anchors.
 The mounting on a structure requires bolts nuts and washers.
 An arm
The arm is joining the two ball-joints allowing precise orientation of the gateway.
Figure 14: ball-joint base, arm and ball-joint head from RAM mounts (EGL1208000)
Figure 15 : mounting on a wall
Figure 16 : mounting on a pole (clamp detail)