User's Manual

When all the camera settings are completed you can validate the angle values with the Test
Camera section.
Figure 20: Test Camera Section to check the Camera angle value
Each button move the camera at a specific position:
● Camera to the North ⇒ Move the camera to the North horizon direction
● Camera to the Mic 1 ⇒ Move the camera to the same direction than the Microphone 1 of
the ATD-300/ATD-301 pod and on horizontal tilt level
● Camera to the Pan 0° ⇒ Move the camera to it’s 0° pan reference and on horizontal tilt
level
● Camera to the Ground ⇒ Move the camera to the ground, at the vertical tilt level.
Remark:
● You can use the Test Camera function during the setting process to validate the 0° Pan
direction or the Tilt mode of your camera
ACOEM | ATD-300/ATD-301 | User Manual FW 1.0.0.4 32