User guide

XP-5R Beam F
3--
during its operation, and allow about 15 minutes for cooling the unit down before
replacing bulb or maintenance as it could be very hot.
y Avoid any inflammable liquids, water or metal objects entering the unit. Once it
happens, cut off the mains power immediately.
y Do not operate in dirty or dusty environment; do clean the fixture regularly.
y Do not touch any wire during operation as there might be a hazard of electric shock.
y Avoid power wires twist other cables.
y The minimum distance between light output and the illuminated surface must be more
than 12 meters.
y Disconnect mains power before fuse/lamp replacement or servicing.
y Replace fuse/lamp only with the same type.
y In the event of serious operating problem, stop using the unit immediately.
y Never turn on and off the unit time after time.
y The housing, the lenses, or the ultraviolet filter must be replaced if they are visibly
damaged.
y Do not open the unit as there are no user serviceable parts inside.
y Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead
to damage or malfunction. Please contact the nearest authorized technical assistance
center if needed.
y Disconnect the mains power if the fixture is has not been used for a long time.
y Do use the original packing materials before transporting it once again.
y To prevent or reduce the risk of electrical shock or fire, do not expose the unit to rain or
moisture.
y Hot lamp explosion hazard. Do not open the unit within 15 minutes after switching off.
y Do replace the bulb once it is damaged, deformed or life-expired.
y Do not look directly at the light while the bulb is on.
y Never touch bulb with bare fingers, as it is very hot after using.
y Do not start on the unit without bulb enclosure or when housing is damaged.
NOTICE:
We strongly suggest that you use Philips Platinum 5R lamp and drive, or
we will not be responsible if there is any quality problem.