User manual

5-
4.3 Easy Controller (by CA-8/CA-9/CA-9RTX)
The easy remote control is used only in master/slave mode. By connecting to the 4-pin
jack of the first unit, you will find that the remote controller on the first unit will
control all the other units for Stand by, Function and Mode selection
Blackout Blackout the unit
Function
Strobe
1. Synchronous strobe in
white
2. Sound strobe in white
3. Sound strobe in color
Select color
1. Red
2. Green
3. Blue
4. White
5. Red + Green
6. Red + Blue
7. Red + White
8. Green + Blue
9. Green + White
10. Blue + White
11. Red + Green + Blue
12. Red + Green + White
13. Red + Blue + White
14. Green + Blue + White
15. Red + Green + Blue +
White
16. Color change by sound
Mode Sound (LED OFF) Manual Color (LED ON)
4.4 Universal DMX Controller
When using a universal DMX controller to control the chain of units, you can set DIP
switch 10 OFF to select 3 channels mode and set it ON to select 4 channels mode. After
choosing channel mode, you have to set DMX address by Dip switches from 1 to 9 to
make sure all the units will receive its DMX signal. Please refer to the following diagram
to know how to address your DMX 512 system in the binary code.