User manual

LED-CTL6
 9A 1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120
ohm 1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug it in the DMX-output of the last unit.
3. Connect the unit together in a ‘daisy chain’ by XLR plug from the output of the unit
to the input of the next unit. The cable can not be branched or split to a ‘Y’ cable. DMX512 is a very high-speed signal. Inadequate or damaged cables, solder joints or corroded connectors can easily distort the signal and shut down the system.
4. The DMX output and input connectors are pass-through to maintain the DMX
circuit, when one of the units’ power is disconnected.
5. Each lighting unit needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
6. The end of the DMX512 system should be terminated to reduce signal errors. 7. 3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
Pin 4/5 Not used
7. Fixture Cleaning The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp, smoky or particularly dirty surrounding can cause greater accumulation of dirt on the unit’s optics. y Clean with soft cloth using normal glass cleaning fluid. y Always dry the parts carefully.
y Clean the external optics at least every 20 days. Clean the internal optics at least
every 30/60 days.

LED-CTL6
 2A 1. Safety Instruction WARNING ♦ Please keep the User Manual for future consultation. If you sell the unit to another
user, be sure that they also receive this instruction booklet.
♦ Unpack and check carefully there is no transportation damage before using the unit. ♦ Before operating, ensure that the voltage and frequency of power supply match the
power requirements of the unit.
♦ It’s important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦ The unit is for indoor use only. use only in a dry location. ♦ The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦ Disconnect mains power before servicing. ♦ Replace fuse only with the same type. ♦ Make sure there is no flammable materials close to the unit while operating as it is
fire hazard.
♦ Use safety cable when fix the unit. ♦ Maximum ambient temperature is Ta: 40℃. Don’t operate it where the temperature is
higher than this.
♦ In the event of serious operating problem, stop using the unit immediately. Never try
to repair the unit by yourself. repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center. Always use the same type spare parts.
♦ Don’t connect the device to any dimmer pack or power pack. ♦ Do not touch any wire during operation as high voltage might be causing electric
shock.
Please read the instruction carefully which including important information about the installation, operation and maintenance