Installation guide

92
PP-32
KOOLMASTER PP-32 REV.04
Load into Control
Press +/- to start
Save into mem stick
Press +/- to start
8.2 Save a Configuration into
the Memory Stick
1- Place the memory stick on the J1 connector,
at the upper left corner of the board, with the
components facing DOWN.
2- Simultaneously press the up and down-arrow
keys during a 5 second
delay. The following message is
displayed :
Load into control. Press +/- to start
3 - Press the up-arrow key once. The
following message is then displayed:
Save into mem stick. Press +/- to start
4- Simultaneously press the +and - push buttons . The
configuration starts being saved on the memory stick. Wait until it is
completely saved.
5- Once the transfer has reached 100%, press the up and down-arrow
keys once again to exit this menu.
6- The new configuration is now saved into the memory stick. Remove
the memory stick from the connector.