Installation guide

KOOLMASTER PP-32 REV.04

Load into Control

Press +/- to start

8. USING THE MEMORY STICK

8.1 Load a Configuration into

the Controller

1- Position the memory stick on the J1 connector

located at the upper left corner of the board,

with the components facing DOWN.

2- Simultaneously press the up and

down-arrow keys during

a 5 second delay. The following

message is displayed :

“Load into Control, Press +/- to start”

3- Simultaneously press the +and - push buttons . The

configuration starts to load into the controller. Wait until it is completely

loaded.

4- Once the transfer has reached 100%, simultaneously press on the up

and down-arrow keys once again to exit this menu.

5- The new configuration is now loaded into the controller. Remove the

memory stick from the connector.