User manual

ACME Electronic Machinery Co., Ltd. ACME
2012/6/20
9
3.UP－－Values are rounded up to the number of decimal places specified by the
current Decimal Place Selector setting.
4.5/4－－Values are round off (0, 1, 2, 3, 4 are cut off； 5, 6, 7, 8, 9 are rounded up) to
the number of decimal places specified by the current Decimal Place Selector setting.
4) Air Combination (Conveyer Type Only)
1.Filter－－Turn the drain for drainage weekly.
2.Regulator－－Keep the pressure at 4~5 Kg.
3.Lubricator－－Keep the lubricant enough. It is necessary to check and fill weekly.
4.FRL System－－This system control the sliding of words plate. Keep the pressure
among 0.8Kg~1.0Kg.
3、Operation
1) The multifunction of the sensor is unpredictable. To prevent the machine‘s trouble
that cause by incorrect measuring, test sheet should be use to check the proper function
of the machine before the measurement work starting and in the end of every measuring
run.
2) The batch number is subject to the number of piece to be in a batch, which will be
set by operator. The batch number that we set will count down after every measurement.
When the piece remains only one, the buzzer will buzz.
3) The compensation is to correct the operational error. The percentage of
compensation basically depends on the operation of measuring. The factors included
softness of leather and measuring skill. Calculate the different measuring result
between skill and non-skill of operator, or carefully measuring and easy pass through, is
a reference of compensation to be set.
4) Operator put the leather on the feeding table and sends the leather pass through the
sensor bridge. To get the maximum area, it is necessary to flatten the leather. Press
leather with proper strength and flatten it is used to be. If the strength of machine that
pull leather is too strong to let us press the leather, the operator should adjust the