User manual

ACME Electronic Machinery Co., Ltd. ACME
2012/6/20
13
SUPPLEMENT
A、Installation
1) Supporting legs
Acme’s bench type measuring machine comes with for supporting legs. For the ease
and safety of the installation screw, please use a forklift or similar equipment to elevate
the machine slightly higher than the vertical height of the legs. Each of these supporting
legs is properly marred and corresponded to angle steel located at four base corners of
the machine. Connect each leg with its respective angle steel by using the hexagonal
bolts and nuts, round and spring washers. Make sure each leg and the angle steel are
securely tighten before lowering the machine and withdraw the for lift equipment.
2) Display Box
Unpack the Display Box from its original carton. Locate the opening on the left side of
the rot table front cover. Flip the front cover until it rests on top of two cylindrical
rubber stoppers, which can be found on the back of the machine. Then connect
connectors together.
3) Calculator (Adding Machine)
Locate the left compartment directly underneath the Display Box Section. Unlatch the
cover and find the 15 Pin Calculator female D-Type into the opening located on the
bottom of the compartment. Unpack the Calculator from its carton. Find the 15-pin
Calculator male connector and connect both.
4) Feeding Table
Install and fasten the Feeding Table onto the steel beam with pre-drilled holes. A Green
ground wire can be found on the underside of the Feeding Table. Secure this ground
wire with the steel beam also.
5) Back Plate
Position of the Back Plate can be changed depending on customer‘s measuring
preference. For a through-feed measuring (two operators), lock the back plate into the
horizontal position. For return-feed (One operator), keep the back plate in the vertical
position.