User guide

on
-
6
D
-
3.2 Rear View
1. POWER
Turns On/Off the power.
2. DC INPUT
DC 9 ~12V, 300mA min.
3. FOG MACHINE
5 pin din socket for connecting DC Fog Machine.
4. STROBE
Trigger non-DMX strobe. Signal +12V DC.
5. AUDIO IN
By build-in microphone or line in.
6. MIDI IN
To receive MIDI data input.
7. DMX IN
This connector accepts DMX signals input.
8. DMX OUT
Two connectors sends DMX signals to DMX fixtures, use 3
pin XLR plug cable to link the fixture together.
9. STAND ALONE
The connectors are used only in master/slave mode, using 5
pin XLR cable microphone jack of the first fixture, you will
find that the remote control on the first unit will control all the
other units for Stand by, Function and Mode.
Fog machine diagram
on
-
15
D
-
4.4.5 Overwrite a Scene
1. Enter Program mode.
2. Press the MEMORY button.
3. Press the button ( 1 ~ 24 ) where the memory ( chase ) is saved and
select the scene that you wish to overwrite.
Press the same button ( e.g. 6 ) repeatedly, you can view the scene
one by one.
4. Create a desired scene.
5. Hold down the SAVE button and then press former selected button
( 1 ~ 24 ) to overwrite a scene.
4.4.6 Delete a Scene
1. Enter Program mode.
2. Press the MEMORY button, choose the desired position ( 1 ~ 24 )
in which you want to delete a scene.
3. Select the scene that you want to delete.
4. Hold down CANCEL and then press the former selected button to
delete a scene.
4.5.1 Copy a Chase
1. Enter Program mode.
2. Press the MEMORY button.
3. Select an existed chase which you want to copy.
4. Hold down PAGE and then press a button ( 1 ~ 24 ) where you want
to copy the chase into it.